CORRECT CRAFT Air Nautique Spezifikationen Seite 64

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 100
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 63
pliers to remove any debris before reassembly.
Replacing Fuel Filter
WARNING: Be careful not to spill fuel; Do not proceed if fuel is spilled.
Gas vapor built up is explosive and could cause severe personal injury,
property damage or even death. Do not smoke while servicing fuel filters
or other fuel system components. Contact your Correct Craft/PCM
dealer for further assistance.
Fuel filters are standard on all PCM electronic fuel injection engines as a part
of the Fuel Control Cell. The FCC has instructions on the bowl. Follow these
instructions and cautions when replacing the fuel filter element.
Prolonged Storage
If you need to store your boat for an extended period of time we suggest you
use a fuel stabilizer such as STA-BIL to prevent the formation of gum and
varnish in the fuel system. Add the recommended amount to the fuel and run
the engine for a minimum of ten minutes to allow the mixture to enter the fuel
system. The following season should be trouble free. Call (800) 621-1251 for
more information.
NOTE: DO NOT re-use old fuel filter components; always replace with a new
fuel filter and gasket.
Exhaust System
The exhaust system should be periodically inspected for leaks to prevent water
and/or exhaust gases from getting into the boat. Check to make sure the
exhaust “flapper” at the transom is securely attached and working properly. All
defects discovered must be fixed right when they are discovered to insure safe
operation.
W
ARNING: Removing hoses from the engine while the boat is in the
water may allow water to enter the bilge. This could sink the boat.
Remove hoses only if you have determined you are doing so safely.
WARNING: Never use your boat without the boarding platform
attached. The boarding platform is instrumental in channeling engine
exhaust gasses, including carbon monoxide, away from the stern. Failure
to have the boarding platform properly installed could result in excessive
carbon monoxide levels in the boat. Excessive carbon monoxide levels
can cause injury or death. Never operate this boat without this specially
designed platform in place.
PCM Transmissions
The transmission fluid level should be checked frequently and fluid added if
necessary. The fluid must measure between the two marks (FULL & LOW) on
the dipstick.
8.6
Sport-Air2002.qxd 8/21/01 9:09 AM Page 8.6
pliers to remove any debris before reassembly.
Replacing Fuel Filter
WARNING: Be careful not to spill fuel; Do not proceed if fuel is spilled.
Gas vapor built up is explosive and could cause severe personal injury,
property damage or even death. Do not smoke while servicing fuel filters
or other fuel system components. Contact your Correct Craft/PCM
dealer for further assistance.
Fuel filters are standard on all PCM electronic fuel injection engines as a part
of the Fuel Control Cell. The FCC has instructions on the bowl. Follow these
instructions and cautions when replacing the fuel filter element.
Prolonged Storage
If you need to store your boat for an extended period of time we suggest you
use a fuel stabilizer such as STA-BIL to prevent the formation of gum and
varnish in the fuel system. Add the recommended amount to the fuel and run
the engine for a minimum of ten minutes to allow the mixture to enter the fuel
system. The following season should be trouble free. Call (800) 621-1251 for
more information.
NOTE: DO NOT re-use old fuel filter components; always replace with a new
fuel filter and gasket.
Exhaust System
The exhaust system should be periodically inspected for leaks to prevent water
and/or exhaust gases from getting into the boat. Check to make sure the
exhaust “flapper” at the transom is securely attached and working properly. All
defects discovered must be fixed right when they are discovered to insure safe
operation.
W
ARNING: Removing hoses from the engine while the boat is in the
water may allow water to enter the bilge. This could sink the boat.
Remove hoses only if you have determined you are doing so safely.
WARNING: Never use your boat without the boarding platform
attached. The boarding platform is instrumental in channeling engine
exhaust gasses, including carbon monoxide, away from the stern. Failure
to have the boarding platform properly installed could result in excessive
carbon monoxide levels in the boat. Excessive carbon monoxide levels
can cause injury or death. Never operate this boat without this specially
designed platform in place.
PCM Transmissions
The transmission fluid level should be checked frequently and fluid added if
necessary. The fluid must measure between the two marks (FULL & LOW) on
the dipstick.
8.6
Sport-Air2002.qxd 8/21/01 9:09 AM Page 8.6
Seitenansicht 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare