CORRECT CRAFT Air Nautique Spezifikationen PDF herunterladen (Seite 7)

Run Mode

First enter the unlocked mode.

Pressing and releasing the start button quickly will put the unit in run mode.

When this is done, power is supplied to the engine ignition,but the engine will

not crank and the ignition indicator light just left of the start button is turned

on. If the start button is not pressed again within 15 minutes the unit will exit

run mode by shutting off power to the ignition and re-enter unlocked mode. If

the user presses and holds the start button, power is supplied to the ignition and

starter for as long as the user holds the start button down. All accessory

buttons are operational in this mode as well. Pressing the stop button will shut

off the engine and the unit is then put back in unlocked mode.

After the engine starts, release the start button.

Automatic Reversion to Locked Mode

If no keypad activity takes place for ten hours after unlocking, the system will

automatically revert to the locked mode. This helps to minimize battery drain.

Automatic Back-lighting

Pressing any keypad button will automatically turn the keypad back-lighting

on for ten seconds. This feature is useful for those that use their boat after dark

to find the appropriate keypad buttons.

Multiple Keyless Ignition Codes

The keyless ignition system has provision for three different ignition codes.

Any of the three codes may be used to unlock or lock the system.

The “Master Embedded Code” is programmed into the system at Correct Craft

Inc. and is not changeable, remaining with the boat for it’s life. This code can

be used to unlock the system, to lock the system and to erase the two user

codes.

The “Primary User Code” is programmed into the system by the owner with

the dealers help at the time of boat delivery. This code is used to unlock the

system, to lock the system, and to add or change the “Secondary User Code”

The “Secondary User Code” is programmed into the system by the owner

when necessary. This code is only used to unlock or lock the system. The

“Secondary User Code” is excellent to use for limited access to the boat.

Programming and/or Changing Primary or Secondary User Code

Note: To help prevent battery drain, when you are finished using the boat

make sure you STOP the engine and LOCK the PME ignition system.(two

steps) Note: The “System Indicator Light” is on the ignition keypad below

the number four (4). The “Ignition Indicator Light” is also on the keypad

below the number one (1)

1.3

Sport-Air2002.qxd 8/21/01 9:08 AM Page 1.3